Hi-Gloss Gel Clear (PLFX-9040)

_______________________________________________________________

Applications

· For creating a 3D wet look

· Print over other colors

· Print directly on garments for a “tone-on-tone” effect

Features

· Produces high gloss, crystal clear prints

· Retains viscosity throughout print run to enable thick prints

_________________________________________________________________________________________________________________

General Information

Hi-Gloss Gel Clear (PLFX-9040) is an improved, specially formulated clear for creating thick and glossy, wet look prints. It can be applied directly on garments or over under base, flashed colors. Finished prints made using Union’s Hi-Gloss Gel Clear (PLFX-9040) have more gloss and better clarity compared to competitive products or Union’s own PLFX-9036 (which is slightly less expensive). Hi-Gloss Gel Clear is crystal clear and does not shear down during the print run, but will maintain a constant viscosity from start to finish.

Mesh

For best results use mesh counts in the 83 range (32 metric) tensioned to your mesh manufacturer’s tensioning guidelines.

Stencils

For best results apply capillary films in the 250-400 micron range. The same techniques used in making stencils for high density printing apply to Hi-Gloss Gel Clear. Avoid using water-resistant capillary films or emulsions, as they can react with the components used to manufacture Hi-Gloss Gel Clear and cause the ink to lock-up and clog the mesh openings. Any solvent resistant capillary films will be acceptable. For optimum results, ensure that all screens are properly exposed according to your capillary film manufacturer’s exposure guidelines.

Toners

Hi Gloss Gel Clear can be tinted with toners (TOPL series) to the desired shade of color. However, adding toners could affect the glossiness of the finished product.

Additives

None recommended, use Hi Gloss Gel Clear directly from the container. Any reduction of this product by adding reducers or extenders will affect the intended look.

Curing Instructions

Hi Gloss Gel Clear will fully cure and withstand repeated washings when the entire ink deposit reaches 320° F (160° C). Because ink is tacky when hot, do not allow garments to fall into a box unattended at the end of the dryer.

Wash-Up

Clean the screens and squeegees with mineral spirits or any screen wash designed for plastisol inks.

Washability

Excellent. Do not dry clean. Do not iron printed areas.

Caution

Always test this product for curing, adhesion, washability and other specific requirements before using in production.

Tip and Tricks Using Hi-Gloss Gel Clear

· Always store with lid tightly on container to avoid contamination of product.

· Flash immediately before printing Hi-Gloss Gel Clear as last down ink.

· On ring spun cotton garments, increase mesh size of under print colors to matte down fibers.

· A slower than normal squeegee and flood speed is required to avoid aeration and improve print quality.

· Bag or remove printed garments from the shop floor promptly; exposure to normal screen chemicals can turn the prints cloudy.

· If prints cloud up they can be rerun through dryer to return them to the original state.

· Slow down belt speed and increase temperature of curing oven to insure proper cure of the thicker print.

_________________________________________________________________________________________________________________

PLFX-9040 Hi Gloss Gel Clear

___________________________________________________________________________________________